damage the tracker or even cause accidents, so please check the power supply first before
installing.
After the backup battery is full, the built in recharging circuit will stop recharging, and if the tracker
do not move, the tracker will go to sleep, then the tracker will cost few power and will not make the
car battery can not start car engine.
5. Back to default set (Factory configuration)
Power off the system, press the external “SOS” button and don’t release, switch the power switch
to ON position to power on the system, a few seconds later the GREEN LED will flash 10 times and
turn ON continuously, and then release the “SOS” button, the tracker is back to default configuration.
Notes: After back to default set, all IP / APN / GPRS / TIME ZONE
setting are deleted and back to default, all preset phone number are deleted
and password change to 123456, all the alarm setting is cancelled, if the
IP/APN/GPRS name& password/TIMEZONE have been changed, you need
set these again by sending SMS.
6. ANTENNA
The Antenna of GSM and GPS are external, please confirm to install the antenna on the place
that have good GSM & GPS signal
7. ON /ACC Control Uploading and Power Saving
This tracker using ACC/ON signal to control uploading and GPS ON/OFF, when the ACC/ON
signal is active, the tracker will turn on GPS and upload location automatically, when the ACC/ON
signal is inactive, the tracker will turn off GPS & GPRS automatically (Stop uploading location), this
can save the car battery power, otherwise maybe cause the battery can not start car engine.
8. Using Condition
The working temperature is -20
0
C to 60
0
C, over this range the specification maybe can not reach
the standard level, the storage temperature can reach to -40
0
C to 80
0
C.
Installation Guide
Before power on, please install the GSM SIM card, the GSM antenna, the GPS antenna
the
microphone and the speaker, according to the map 1, like below:
Install the wire set, according to map 2, like below:
