LC Packings Probot 161403, User Manual

Page: 43 / 118

Installation and Getting Started
User’s Manual Probot
D960R3
2-23
2.7.4 C Checking/Modifying the Task Parameters
To check or modify the task parameters, select the task that needs to be
checked in the task list. The task parameter box (e.g. Basic Fractionation) will be
presented in the Application Editor window (FIGURE 2-19).
Task List Task
Parameters
FIGURE 2-19 Task List and Parameters
FIGURE 2-20 Basic Fractionation Task
The most common task, which is to be performed with the Probot, is a time
controlled fractionation task. The ‘Basic Fractionation’ task is provided to
simplify the setting up of such a task, and it needs very few parameters to run it.
FIGURE 2-20 shows the parameters box. The Basic Fractionation box is divided
in three sections.
• 1 – How… - The column flow rate and the matrix flow rate is specified (as
multiples of the column flow rate) via this box. The Dispense 10 µ l of matrix
prior to fractionation option compensates the dilution of the matrix solution in
the case the needle rests in the wash vial between runs.
•
2 - When… - All timing related parameters are programmed via this box. The
Collection time is the maximum spotting time of the corresponding task.
Regardless of the number of available spots, the current task will be aborted if