24
For HELP, call La-Z-Boy
®
Spas at 1.800.465.2933.
CAUTION:
If water does not flow from the jets after 2 minutes, turn
power off at the main panel and bleed air from the system (see
page 36). Turn power on again. Sometimes momentarily
turning a pump off/on will prime it. Only do this four times
.
7) Turn on the circuit breaker. Set the desired temperature by using the up or down
keys.
8) Push the jets 1 keypad to turn on the low speed pump. Check to ensure water is
coming from some of the jets. If the water is not flowing out, open the air bleed valve
slightly to release trapped air. Close the valve when the pump pushes water out of air
bleed. Push the jets 1 keypad and the pump will turn on high speed. Observe closely
to ensure adequate water flow. Push the jets 2 key pad (if equipped) and pump 2 will
turn on high speed. Observe to ensure adequate water flow. If there is no water flow
through the jets, the pumps need to be primed.
9) Re-attach the equipment access panel.
10) Heating will occur at a rate of 5-12ºF or 3-5ºC per hour, depending upon the size of
the spa / hot tub and the electrical circuit.
11) Ensure proper water chemistry is necessary only after completing the above steps.
12) To conserve energy and ensure your spa / hot tub is ready for use, place the
color coordinated cover securely on the spa.
