19
18
Power Sofa with Headrest
and Lumbar Assembly Instructions
Base Rail
Lock
Washer
Upper Jam Nut
Lower Jam Nut
Adjustable Glide
4. Adjust the glides to ensure a height that provides a clear path for operation of the legrest. Each glide is
attached to the base rail by one jam nut and one lock washer on top of the base rail, and one jam nut
on the bottom of the base rail.
•
To extend the glide, loosen the upper jam nut by rotating clockwise. Turn the lower jam nut
clockwise to the desired height.
•
Tighten the upper jam nut by rotating counterclockwise.
•
Repeat steps one and two for each adjustable glide on the unit, if needed.
•
Repeat this procedure, as necessary, to adjust the front height of the unit and level it.
5. Locate the motor connector, one behind each reclining seat (F
IGURE
6). Connect the Y-cable to the
motor connectors and to the power supply.
•
Align one motor connector to a long lead Y-cable connector, push the connectors together until
seated and close the locking cover to secure the connection (F
IGURE
7). Repeat this for the other
motor connector and Y-cable long lead. Then align the short lead of the Y-cable to the power supply
connector, push the connectors together until seated and close the locking cover to secure the
connection (F
IGURE
8).
6. Connect the 120 volt power cord to the power supply (F
IGURE
9). Do not plug in until instructed in
the
Operating Instructions
.
7. Proceed to the
Battery Backup Assembly Instructions
.
To Remove a Back:
1. Unplug the 120 volt power cord and disconnect the power supply from the Y-cable. Reverse the
Assembly Instructions
steps. When lifting the back up from the body, to lay across the arms,
make sure
to do so slowly and carefully to prevent damage to the electrical connections.
2. Repeat step 1 for the other side of the back.
F
IGURE
6
F
IGURE
7
F
IGURE
8
F
IGURE
9
Y-Cable Long Leads
Make this
connection
Power Supply
Y-Cable Short Lead
Make these
connections
Make this
connection
Power Supply
120 Volt Power Cord
Power Sofa with Headrest
and Lumbar Assembly Instructions
Motor Connector
