100 x 190mm
Important:
When searching through the Library for some older
devices, if the power on/off function of your device is
not infra-red controlled you need to follow steps 2 to 6
above and start searching:-
-
Press " " (power) key and another important
function key alternately until your device responds
to the expected function, press the same device
mode key (e.g. TV) to lock in the code.
-
Press " " (power) key & "
C
" alternately,
or;
-
Press " " (power) key & "
1
" alternately.
Note:
-
Each time you press the " " (power) key, the LR
will skip to the next code and send out a POWER
signal trying to turn off your device.
-
If you failed to stop pressing " " (power) key in
time when your device has been turned off, turn on
your device again immediately. Before the indicator
goes out, press " " on the LR to skip backward.
Repeat the step 7 above and lock in the code.
-
If the red LED indicator flashes twice after you
pressed the " " (power) key, you are already at the
last code of the library.
-
Besides device keys, " " (power) key and " "
(mute) key, all keys can be operated if the remote has
entered search mode.
7. Aim the LR at your device (e.g. TV); press the " "
(power) key repeatedly every 1-2 seconds until the
device has been turned off. The red LED indicator
will blink once each time you press the " " (power)
key to indicate your remote is scrolling thru the code
library. Once your device has been turned off,
immediately press the same device mode key (e.g.
TV) to lock in the search code and the red LED
indicator should go out.
*
Simply repeat the above setup procedures to search
the Device Code for your VCR, SAT, DVD and other
Devices. (Remember to press a correct Device Mode
Key and correct Search Code in step 2-5 above).
*
For set up of Auxiliary devices (AUX 1-4) press
"
SHIFT
" followed by the desired device key (AUX
1-4) then follow steps 3-7 above.
Note:
The search process can take several minutes due to the
number of codes stored in the library.
Note:
You cannot search through the code library for DVR
devices.
Important:
During set up mode, the red LED indicator will blink
twice and the set up procedure will be terminated if any
of the following conditions occur;
-
No key has been pressed for more than 8 seconds.
-
An invalid code number has been entered.
-
An invalid key (not a numeric key) has been pressed.
11
10
