Page 4 of 5
Assembly Steps:
Step1: Turn the table rim (A) upside down on a soft, non-abrasive surface carefully.(See Figure 1)
Figure 1
Step2: Attach the table legs (B) to table rim (A) with M6x15mm hex head bolt (D1), M6x30mm hex
head bolt (D2), M6 washer (E) using hex wrench (G). NOTE: Please do not fully tighten the bolts at
this step. (See Figure 2)
Figure 2
Step3: Attach the connector ring (C) to table legs (B) with M6x15mm hex head bolt (D1), M6
washer (E). Tighten all bolts with hex wrench (G). Cover all the bolts with bolt cap (F). (See Figure
3)
Figure 3
