Layzee Car Port – 4 Post
Layzee Living
London W1W 7LT
info@layzeeliving
02078683959
4
Panel and glazing bar preparation
Before commencing assembly, the outer panel edges and glazing bars will need to be pre-drilled as per
the following instructions using the spacings indicated in the table below.
Panel length
2M
2.5M
3M
3.5M
4.5M
Holes per panel/bar
4
5
6
6
8
Hole spacing (mm)
600
575
560
660
614
Wall plate height (top edge - mm)
2550
2637
2723
2810
2984
Post distance from wall (mm)
1707
2200
2690
3180
4170
Panel length table
Glazing bars
Measure 100mm from either end of the glazing bar (fig.1) and using the 5mm drill bit supplied, drill the
first hole by using the central groove in the base of the glazing bar as a guide and drilling through as
shown (fig. 2). Using the Panel length table, now measure along the glazing bar the appropriate length
from the centre point of the first hole and continue to add the remaining holes in the glazing bar in this
manner. The final hole should be approximately 100mm from the opposing end of the glazing bar.
fig.1
fig 2.
