Laxxon LX-D10004H, User Manual

Page: 161 / 210

151
Parameter Function
Default Gateway Here you can input the default gateway.
Please note system needs to check the validity of all IPv6
addresses. The IP address and the default gateway shall
be in the same IP section. That is to say, the specified
length of the subnet prefix shall have the same string.
TCP Port Default value is 37777.
HTTP Port Default value is 554.
UDP Port Default value is 37778.
Max Connection Network user max amount. The value ranges from 0 to 20.
O means there is no user can access current device.
z
PPPoE
Please input the PPPoE user name and password you get from the IPS (internet service provider)
and enable PPPoE function. Please save current setup and then reboot the device to get the
setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN
from the IP address column.
Note:
After PPPoE successful dial, you need to go to the device local end to get device current IP
address and then use the client-end to access this IP address.
Advanced
The advanced interface is shown as in Figure 7-37.
z
Multiple cast
Please refer to chapter 5.3.5.3 for detailed multiple cast setup information.
Figure 7-37
Email
The email interface is shown as in Figure 7-38.