21/23
Version: 4.0/1
vsm LCD Button Panels (LBP)
vsm LCD Button Panels User Manual
Pin
Signal
Color of a standard TIA-568A-shielded twisted pair patch
cable (CAT5 or higher)
2
TX-
green
3
RX+
white/orange
4
NC
blue
5
NC
white/blue
6
RX-
orange
7
NC
white/brown
8
NC
brown
Notice for wiring:
NC: No connection; do not connect to any signal or supply.
Only use shielded CAT5 (or higher standard) -specified networkable. Refer to TIA-568A or TIA-568B for wiring.
Do not use cable-traces longer than 100m (328ft) between the device and network-switch for 100BASE-T
communication.
Make sure to keep to wiring standards and use shielded RJ45-plugs for shielded cable on both ends of the line.
8.4
Connectors (Accessories)
8.4.1
Power
Connector for the ENC17: 12 V DC-supply: 4-Pin connector (MC 1,5/ 4-STF-3,81) locked with two screws.
It is understood that if NOT using the original Power-Supply-Unit, you need to make sure that there is only one
single 12V DC-supply with a maximum tolerance of 3% within the 12V. It has to be taken care, that the external
supply uses a circuit-breaker, fuse or another kind of short-circuit-protection to never allow a current >5A
@12VDC per device. Do NOT connect the device at reverse polarity at any time.
Connector for RF-ID-Tag-Reader for 12 V DC supply:
2-pin low voltage PSU connector 2.1mm
(Mounted on power-supply delivered with each RF-ID-Tag-Reader)
It is understood that if NOT using the original Power-Supply-Unit, you need to make sure that there is only one
single 12V DC-supply with a maximum tolerance of 3% within the 12V. It has to be taken care, that the external
supply uses a circuit-breaker, fuse or another kind of short-circuit-protection to never allow a current >5A
@12VDC per device. Do NOT connect the device at reverse polarity at any time.