21
GENERAL TROUBLESHOOTING
Fig. 16
■ Make sure the gap is between 0.012 and 0.015 in. (0.30-0.40 mm) as instructed in step 3 of the
Ignition Coil Replacement section (Fig. 17).
Fig. 17
Ignition Coil Replacement
(See Figs. 18-19)
■ Remove the rear engine cover, connection cover and front engine cover. Refer to step 5-9 in Ignition
System section.
■ Remove the spark plug cover. Rotate the quincunx wrench counter-clockwise to remove the 2
screws (marked as 1 & 2, screw 1 with a connector) on the ignition coil. Then remove the ignition
coil (Fig. 18). Replace with a new ignition coil. When installing the new ignition coil, make sure the 2
screws (marked as 1 & 2) are secured into the correct place as shown (Fig. 19).
Front Engine
Cover Assembly
Terminals of Stop
Switch Cables
Feeler Gauge
