LawnMaster GT1415, Operator'S Manual

Page: 15 / 40

WARNING
WARNING
Winding new line onto a spool (See Fig. 17 - Fig. 19)
• Only use .065" repl acement line
• You may wind new cutting line onto an empty spool.
• Replacement packs of cutting line are available from dealer.
• Remove the empty spool from the grass trimmer as described above.
• Remove any remaining cutting line from the spool.
• First feed 4 inches of cutting line ⑥ into the two eyelet ⑦ in the upper section of the spool as show
• Wind the cutting line onto the spool in the direction of the arrow. make sure to wind the line on
neatly and in layers. Do not criss-cross.
• Feed cutting line ⑥ into the two eyelet ⑦ in the upper section of the spool as show
• Finish winding, Produce as described above to fit the spool on the grass trimmer. Do not forget to
release the cutting line from the parking slot.
Use LawnMaster replacement spo ol; part # RS0101
MAINTENANCE
15
If the cutting lines protrude beyond the trimming blade, cut them off so
that they just reach the blade.
Only use the appropriate type of cutting line.
Bits of the cutting line could cause injury when being flung out.
Fig. 17 Fig. 18 Fig. 19
Ľ
ļ