ASSEMBLY
14
ASSEMBLING THE HANDLE
(See Figs. 2-3)
■ Insert lower handles (6) ONTO and over the exposed Attachment plate bolts at the rear of the
motor housing. Make sure the power cord clips (3) on the handles are BOTH facing up.
On each side, place washer (21) over bolt tip and thread locking lever (4) onto it. Fold locking
lever (4) down to secure handle into position. (Fig. 2)
NOTE:
For ease of use, the overall handle pitch angle can be raised or lowered by choosing an
attachment point that is higher or lower on the attachment plate. (Fig. 2)
Fig. 3
Fig. 4
Fig. 5
Fig. 2
A - Power Cord Clip
(Sujetador del cable de energía)
B - Attachment Plate
(Placa de fijación)
A
6
4
B
■ Attach the upper handle (11) to the lower handle (6) using attachment plate bolts (23), washer
(21) and locking levers (4).
There are three adjustment positions. Choose the position which is best for you. (Fig. 3)
■ Secure the handle into position by turning the locking lever (4) to tighten and then folding the
lever down. Do not apply excessive force to fold the lever down or it may break. Loosen the
lever to the point where it will fold down without breaking. (Fig. 4)
■ Secure the power cord (25) with the cord clips (3). (Fig. 5)
6
21
4
11
18
21
4
4
4
3
6