16
11. WIRELESS REMOTE CONTROL
(If applicable)
OPERATING
1. Turn on the remote control switch.
2. Press the START button and hold for
more than 0.3s for startup.
Note: Sometimes the generator can take
a few attempts to start in cold weather.
If machine does not start within the first
1O seconds, wait for 30 seconds before
attempting again.
If the motor turns a little then stops when
you press the Start button, it may indicate
a low battery. Charge the battery before
operation or start by recoil start.
ONCE ALL STEPS COMPLETED
After all tasks above is completed, the
engine can be normally loaded.
WARNING
Do not start or close the generator when
the output terminal of the generator is
connected to an electric device and the
electric device is in “ON” state.
12. CONNECT TO ELECTRICAL DEVICES
1. Inspect power cord for damage prior to
use. A damaged power cord is a hazard
and can cause electric shocks from
crushing, cutting or heat damage.
2. Make sure that the generator has been
properly grounded. If the electric devices
require grounding, the generator must
ground.
3. Allow the engine to stabilise and warm
up for a few minutes after starting.
4. Make sure that the electric devices are
in “OFF” position.
5. Connect and start the electric devices.
6. Turn off all electrical devices and
disconnect them from the generator.
7. If the generator is supplying power to
several electric devices, start from the
smallest device first through to the largest
one last.
DANGER
If connected devices overheat, turn them
off and disconnect them from the
generator.