Thank you for purchasing the Lawn Star trimmer which is one of the finest and most advanced
trimmers today’s technology can produce. Before you begin using it, please read this manual carefully
and familiarise yourself with the control and the proper use of this product to ensure you get the best
possible performance from it.
SAFETY PRECAUTIONS
Inspect your trimmer and its supply/extension cable before each operation. If any part is damaged or
worn, repair or replace before operation . Do not operate with damaged or tangled supply/extension
cable. Keep cable away from cutting head.
Use only genuine Lawn Star (Pty)Ltd. replacement parts when servicing or repairing the unit. These
parts are available from your supplying dealer or service agent. Use only genuine Lawn Star
replacement nylon cutting line , never metal.
WARNING : To prevent electrical shock hazards , use only extension cables suitable for outdoor use,
with splash-proof socket outlets, preferably protected by sensitive Residual Current Device (RCD)
with tripping current 0f not more than 30 mA.
Disconnect the unit from the power supply when unattended or not in use, before servicing or when
changing accessories, such as the spool.
It is essential that the operator wears safety goggles , protective clothing and sturdy , non-slip
footwear.
Do not use your trimmer for any jobs other than those for which it was intended. Do not use for edge
trimming unless adequately guarded. Do not force your trimmer. If motor labours, pull away from
grass.
Do not operate trimmer without a line-trimming blade as over-extended line is dangerous and will
damage motor and invalidate warranty.
Use care in picking up or holding the unit. Do not grasp the line-trimming blade located at the edge of
the underneath side of safety guard.
Avoid unintentional starting. Do not carry a plugged-in unit with your fingers on the switch. Inspect
the area to be cut and remove all debris that could be entangled in the cutting head. Also remove any
object that the unit may sling during cutting.
Avoid dangerous environments. Do not use the unit in poor light or in damp or wet locations. Do not
use in the rain. Do not use on steep slopes , especially if damp. Work across slope faces , not up and
down. Do not over-reach. Ensure good footing and balance are maintained.
Keep hands and feet clear of the rotating head while unit is in use. Cutting elements continue to rotate
for a few seconds after switch-off.
Do not allow children under 16 , nor anyone who is not familiar with these instructions to use the
trimmer. Children , pets and onlookers should be kept at least 15 meters away from the work area ,
unless shielded by an effective solid barrier.
When not in use, store the unit indoors in a dry and locked place , out of reach of children.
PREPARATIONS FOR USE
For models with edging wheel, remove the wheel and bracket from the bag and attach to the guard by
inserting and tightening the two screws supplied.(Fig.1 )
Mount the guard from below by passing over the cutting head until the guard bayonet projections
locate into the housing flange recesses ( Ensure that the cutting lines are not trapped ). Turn the guard
until it locks into place at the end of its travel ( Fig.2). Insert locking screw supplied and tighten ( Fig.
2- No 3 )
Attach “D” assist-handle to the upper half of tube by clipping over the shaft (Fig.3-No 1). Adjust to the
most comfortable position for trimming, then fit and tighten the bolt and knob provided (Fig.3-No 2).
Rotate the “D” assist-handle through an angle of 180 degrees when edging with your trimmer.
Connect the plug provided with the trimmer , to a suitable female socket. Attach to an extension cord
not more than 40 meters of length. Use 2-core insulated cable , minimum (HO5VV-F ) 2x1,0mm , in
turn connected to a suitable mains connection plug. All components should meet your national , IEC or
EN specifications.
THE USE OF THIS TRIMMER FOR COMMERCIAL OR RENTAL PURPOSES WILL
INVALIDATE THE WARRANTY.
