C
6
1
4
2
3
5
1 0
HEDGE TRIMMER INSTRUCTIONS MANUAL
1)
Slacken the knob (3) on the clamp (1)
located on the motorized unit.
2)
Move closer and introduce the shaft (2) in the
clamp, making sure the flexible peg (5) matches
the hole (4). Push fully down until the flexible
peg comes out of the hole (see stage 6). Fully
tighten the screw knob, as shown in the picture.
This fitting position A = 0° is suitable for
usage shown in figures 13-14.
Also see fitting position B = 90° suitable for
usage shown in Fig.13.
POSITION C
1)
Slacken the knob (3) on the clamp (1)
located on the motorized unit.
2)
Move closer and introduce the shaft (2) in
the clamp, making sure the flexible peg (5)
matches the hole (4). Push fully down until the
flexible peg comes out of the hole (see stage 6).
Fully tighten the screw knob, as shown in the
picture.
This fitting position C = 180° is suitable for
usage shown in fig.15.
WARNING! Start the engine only after
connecting the bottom drive shaft to
the upper drive shaft. Make sure the
clamp screw knob (fig. 6 item 1) is
firmly tightened.
WORKING ANGLE ADJUSTMENT
The blades may be adjusted in 8 different
positions; up (fig. 7) and down (fig. 8).
WARNING! The working angle
adjustment operation must be
carried out only when the blades
have come to a complete stop (engine off).
WARNING! When the hedge trimmer
is in operation, the reduction unit will
heat up. Do not touch the box without
safety gloves.
Danger of burns
1)
Slacken the tilting selector switch
lockout knob (fig. 9 item 1).
2)
Tilt the blades in the desired position (fig. 10)
3)
Tighten the knob.
BELT HOOK AND FIXING RING (Fig. 11)
(refer to the Brushcutter manual. The same
conditions apply).
5. REFUELLING
(pls refer to the Brushcutter manual).
