Accessories
GB–28
5.
Secure chute assembly to housing with capscrew
(Fig. 42).
6.
Remove knob and bolt securing left side upper
and lower handle sections (Fig. 44).
1011
2
1
3
4
Figure 44
1.
Knob
2.
Bolt
3.
Hanger clamp
4.
Bag hanger
7.
Hold hanger clamp on outside of handle
sections. Insert handle bolt from inside of handle
sections through holes in hanger clamp.
8.
Position bag hanger leg into hanger clamp
groove and secure with knob. Repeat steps and
assemble clamp and hanger to right side handle
sections.
9.
Close rear of bag by folding sides in and
pressing interlocking rear handle halves together
(Fig. 45).
1012
Figure 45
10. Position rear bag handles into bag hanger on
handle.
11. Grasp bag assembly handle and slide over flange
of grass chute (Fig. 46). Push downward on
handle until it seats into position.
1010
Figure 46
Bag Adjustment
When handle height is changed bag adjustment may
be required. A properly adjusted bag should be taut
on top cloth area between front bag handle and rear
bag hanger handles. If bag is too tight or too loose,
adjust as follows:
1.
Remove bag from rear bag hanger. Remove
bolt(s) and knob(s) securing hanger clamps to
handle sections (Fig. 47). Hanger clamps have
four adjustment holes.
1011
2
1
3
4
Figure 47
1.
Knob
2.
Bolt
3.
Hanger clamp
4.
Bag hanger
