Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 5 hours
• Change the engine oil.
Before each use or daily
• Check the engine oil level.
• Ensure that the engine stops within 3 seconds after releasing the blade control bar.
• Clean grass clippings and dirt from under the mower.
Every 25 hours
• Replace the air filter; replace it more frequently in dusty operating conditions.
Before storage
• Empty the fuel tank before repairs as directed and before annual storage.
Yearly
• Change the engine oil.
• Lubricate the wheel gears.
• Lubricate the upper handle.
• Replace the blade or have it sharpened (more frequently if the edge dulls quickly).
• Refer to your Engine Operator’s Manual for any additional yearly maintenance
procedures.
Yearly or before storage
• Charge the battery monthly (or as needed) and before storage.
Important:
Refer to your
Engine Operator’s Manual
for additional maintenance procedures.
Preparing for Maintenance
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the spark plug wire from the spark plug
(Figure 38) before performing any maintenance
procedure.
Figure 38
3. After performing the maintenance procedure(s),
connect the spark plug wire to the spark plug.
Important:
Before tipping the mower to change
the oil or replace the blade, allow the fuel tank
to run dry through normal usage. If you must
tip the mower prior to running out of fuel, use a
hand fuel pump to remove the fuel. Always tip
the mower onto its side with the air filter up.
Tipping the mower may cause the fuel to leak.
Gasoline is flammable, explosive and can cause
personal injury.
Run the engine dry or remove the gasoline with
a hand pump; never siphon.
16
Summary of Contents for 10666C
Page 22: ...Notes 22 ...
Page 23: ...Notes 23 ...
