Checking the Engine Oil Level
Service Interval:
Before each use or daily
1. Remove the dipstick, wipe it clean, and fully install
the dipstick (Figure 16).
Figure 16
2. Remove the dipstick and check the oil level
(Figure 16). If the oil level is below the
Add
mark on
the dipstick, slowly pour oil into the oil fill tube to
raise the oil level to the
Full
mark on the dipstick.
Do not overfill.
(Max. fill: 20 oz., type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick securely.
Adjusting the Cutting Height
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
•
Stop the engine and wait for all moving parts
to stop.
•
Do not put your fingers under the housing
when adjusting the cutting height.
If the engine has been running, the muffler will
be hot and can severely burn you. Keep away
from the hot muffler.
Adjust the cutting height as desired. Set all four wheels
to the same height.
Note:
To raise the mower, move all 4 cutting height
levers forward; to lower the mower, move them all
rearward.
Figure 17
Adjusting the Upper Handle
Height
You may raise or lower the upper handle to a position
comfortable for you.
Note:
You cannot raise the upper handle higher than
the angle of the lower handle.
1. Loosen the upper handle knob (Figure 18).
Figure 18
2. Move the upper handle to the desired position
(Figure 19).
10
Summary of Contents for 10666C
Page 22: ...Notes 22 ...
Page 23: ...Notes 23 ...
