bled before use.
•
Ensure that power sockets used are correct
for the machine.
•
Never grasp the power cord with wet
hands.
•
Check that voltage indicated on the ra-
ting plate is the same as the supply vol-
tage.
•
These machines are not suitable for va-
cuuming health endangering dusts or
inflammable/explosive substances (like
ash and soot).
•
Never leave the equipment unattended
whilst in use.
•
Never carry out any maintenance on the ma-
chine without first disconnecting from the
mains supply or when it is left unattended
or reachable by children or disables..
•
The power cord should not be used to pull
or lift the machine.
•
The machine should never be immersed and
never use water jet against the appliance to
clean it.
•
When using the machine in wet rooms
(e.g. in the bathroom) only connect it to
sockets which are connected in series
with a ground fault circuit interrupter. In
case of doubt, consult an electrician.
•
Periodically examine the power cord and
machine for damage. If any damage is
found, do not use the appliance but con-
tact your service centre for repair.
•
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
centres or similarly qualified people in
order to avoid a hazard.
•
If an extension cord is used, the plug and so-
cket must be of watertight construction.
•
Before vacuuming liquids, check the float
functions correctly. When vacuuming li-
quids, and when the tank is full, a float clo-
ses the suction opening, and the vacuum
operation is interrupted. Then switch off the
machine, disconnect the plug and empty
the tank. Regularly clean the water level li-
miting device (float) and examine it for signs
of damages.
•
If the machine overturns, it would be recom-
mended to stand it up before switching off.
•
If foam or liquid escape from the appliance,
switch off immediately..
•
The equipment should not be used to va-
cuum water from containers lavatories,
tubs, etc.
•
Aggressive solvents or detergents should not
be used.
•
Service and repairs must be carried out by
qualified personnel only. Only use manufactu-
rer original spare parts for service repair.
•
The manufacturer cannot be held responsi-
ble for any damage/injury caused to persons,
animals or property caused by misuse of the
appliance,
USE
(see fig.
②③
)
• Be sure that switch is in off position (0) OFF
and connect the machine to a suitable socket.
• The machine must be always kept on horizon-
tal bases, in a safe and stable way.
• Insert the suitable filters for the proper use.
•
Never use the appliance without filters .
• Use the most suitable accessories for the re-
quested usage.
• Put switch on (1) ON position in order to start
the machine.
• When job is over, switch off (0) OFF and keep
away the plug from the socket.
• If the appliance is used with especially fine
dust (size below 0.3 µm) the filter supplied will
require cleaning more frequently. For espe-
cially demanding applications, the use of spe-
cific filters supplied as an optional (Hepa) may
be necessary.
FILTER CLEANING
(see fig.
④
)
12
Summary of Contents for Windy 120 IF
Page 7: ...7 ...
