Lavor SWL 990 ET, Instructions And Operating Manual

Page: 24 / 138

24
•
FLAP-LIFT PEDAL:
By pressing the flap-lift pedal Part. 1 Fig. 9 , the front seal
Part. 2 Fig. 9 lifts up for picking up a large objects .
Suitable for collecting leaves, cigarette packets, etc .
•
BRAKE PEDAL:
By pressing this pedal Part. 1 Fig. 10 , the machine slows down
and stops (until the pedal is released) .
•
PARKING BRAKE:
To leave the machine in parking position, proceed as follows:
press the brake pedal with the left foot and then insert the
stop tooth with the right foot by pressing lever .
To release the parking brake, simply press the pedal
Part. 4 Fig. 10 again .
•
FORWARD AND REVERSE PEDAL: (only for battery
version)
Part. 3 Fig. 10 . This pedal has two functions depending on the
position of the operation switch Part. 1 of switchboard: when the
switch is in forward position, the machine moves forward when
the pedal is pressed . When switch is positioned in reverse, the
machine reverses . For safety reasons, the reverse speed of
the machine is very low. When the switch is in central position,
the machine moves neither forward not in reverse .
•
FORWARD AND REVERSE PEDAL: (only for internal
combustion engine)
Part. 3 Fig. 10 . This pedal has two functions depending on the position .
By pressing the right side (with arrow pointing UP) the machine goes
forward while by pressing the left side (with arrow pointing DOWN) the
machine withdraws . For safety reasons, the reverse speed of the
machine is very low.
•
SIDE BRUSH ENGAGEMENT LEVER: (for all models)
The engagement lever Part. 1 Fig. 10 makes it possible to lower the
brush from the driving seat . Remember that the side brush must only
be used for cleaning edges, profiles and corners and that it continues to
rotate when the machine motor is rotating . To lower and then activate
the side brush push forward lever Part. 1 fig. 10 ; to disconnect the
side brush bring back the lever in the initial position by pulling it back .
ATTENTION:
NEVER TOUCH THE SIDE BRUSH WITH YOUR HANDS AND NEVER PICK UP THREADED
MATERIALS.
•
SUCTION OFF KNOB: For all models.
Fitted to both models Part. 1 Fig. 6 . When this knob is pulled outwards, suction is disengaged . Disengage the
suction every time the filters need shaking or when passing over damp areas (with the motor on) .
•
CENTRE BRUSH ENGAGEMENT LEVER: For all models.
This lever Part. 2 Fig. 6 makes it possible to engage and disengage the centre brush . By sliding the lever down
along the slot, the work position is lowered, while when the lever is slid upwards and inserted in the notch, the
centre brush is disengaged .