NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE
CONNECTED TO A POWER SOURCE
Diesel Fired Radiant Heater User’s Manual
© 2020, Lavorwash
Maintenance - PT-125 SS
Long Term Storage:
1. Unscrew the drain bolt and drain all fuel.
(See Figure 17)
2. Using a small amount of Kerosene or diesel,
rinse and swirl the fuel inside the fuel tank.
NOTE: NEVER MIX WATER WITH FUEL. It will
cause rust inside the tank.
3. Empty the tank completely.
IMPORTANT: Never store leftover Kerosene
between seasons, using old fuel can
damage heater.
Store Heater in a dry, well ventilated area.
- Be sure that the storage area is free of dust
and corrosive vapors. Repack the heater
in the original packaging and keep user’s
manual in an easily accessible place.
Service:
DO NOT TAMPER WITH THE UNIT. HAVE AN
EXPERIENCED SERVICEMAN MAKE ANY
NECESSARY ADJUSTMENT OR REPAIRS.
We suggest following a maintenance schedule as
follows:
FUEL / FUEL TANK:
Flush tank every 200 hours of operation or as
needed. DO NOT flush with water, use fresh
Kerosene only.
SPARK PLUG:
Clean and re-gap every 600 hours of operation,
or replace as needed After removing the Spark
Plug, clean the terminals with a wire brush.
(See Figure 18)
NOZZLES:
Nozzles should be cleaned or replaced at least
once per heating season. Contaminated fuel
could make this necessary immediately.
To clean dirt from nozzle, blow compressed air
through nozzle front. It may be necessary to
soak nozzle in clean diesel to help loosen any
particles (Figure 19).
11
Never service heater while it is
plugged in or hot!
WARNING
TIP: Follow the long term storage
instructions to flush the tank.
SPARK PLUG
Figure 19
Figure 17
Figure 18
