2
TECHNICAL CHARACTERISTICS:
Water supply
connection
Connection on left side with elbow
Inlet connection type
Female ¾” GHT
Outlet connection type
Male ¾” GHT
Chemical product
channel flow rate
Water supply of 8gal/min flow rate and 50psi:
2.5 gal/min
Rinse channel flow rate
Water supply of 8gal/min at 50psi:
3.4 gal/min
Maximum dimensions
H = 400mm (15.75”)
L = 330mm (13”)
D = 160mm (6.3”)
Working pressure
Min 22 PSI (1.5 bar)
Max 85 PSI (6 bar)
Optimum: 30 – 60 PSI (2 – 4 bar)
Temperature
Max 140°F (60°C)
PLEASE READ THE FOLLOWING WARNINGS BEFORE INSTALLING OR SERVICING THE
CLEANING
STATION
Make sure that the water supply pressure is between 22 -85 PSI, in case of excessive pressure use a
pressure regulator to avoid breackage.
Make sure that the water supply temperature does not exceed 140° (60°C)
The ProTwin’s fittings have been tested with commonly used liquid detergents mixed with water.
Check that the detergent used is compatible with polypropylene.
Install the station near as possible to a water supply connection point.
Mount the
CleanJet
considering easy access for cleaning and routine maintenance.
WARNING: Disconnect water supply before servicing the
CleanJet
.
WARNING: THE MAXIMUM OPERATING PRESSURE is 6 bar (85 PSI) and is intended as a maximum
static pressure applicable to the system. Care should be taken that the equipment cannot produce
scenarios of over pressurization, which could cause damage to the structure of the system. The
use
of a pressure reducer is always recommended and the installation of a tap on the water outlet
of the
system which can be closed when the system itself is not in use.
WARNING: Follow common safety procedures. Use adequate protection for the eyes, face, hands,
and clothing.
We constantly work to improve our products and reserve the right to make changes at any time
without prior notice.
Failure to follow these safety precautions may cause personal injury or damage to the equipment.
Only use recommended accessories.
