Installation and Use
BLUEPOD TECHNICAL SERVICE
Tel: 1800 800 255 Email: [email protected]
Copyright Bluepod Coffee Co Pty Ltd
Page 5 of 8
LB3202 Colibri
DATE OF ISSUE: 27/01/2011
Initial Setup after installation
1. Ensure the electricity supply is
OFF
and the water supply is
ON.
2. Machines are supplied with a Brita water filter, this
must
be fitted and
flushed
before using the machine. Do not proceed further until this is carried out.
3. Open the main machine door with the silver key.
4. Open the external grey lid on the top right side of the machine. This lid will not open
without the main door open. It is used to fill the milk canister, this is labeled on its
front.
5. The chocolate canister is located on the hinged metal bracket inside the main door, it
should be clearly labeled
6. Fill both canisters; each compartment will take up to a bag of product.
Do not
overfill.
The lids will not close and the machine will not operate.
7. Close the machine door. Switch on the mains electricity supply. The front LCD will
power up while the machine runs a short diagnostic program. Water may flow from
the dispensing nozzles; this will run into the drip tray to be emptied after.
8. “Temperature” should appear on the LCD display for some minutes after which it will
show “Ready for use”
9. Open the transparent plastic door on the top left of the machine. Insert a pod then
press Mokaccino. Discard this first drink, it is only to prime the powder conveyers.
10. Congratulations, the machine is now ready for use.
11. Make a selection from short black, long black, latte, mokaccino, cappuccino, strong
hot chocolate, hot chocolate or hot water.
12. Wait for the display to show ‘Take your drink’ and then enjoy!
