Something not working?
26
If you do not find the required information in this manual to remedy a
disturbance, please call the customer service.
Replace the interior light
0
A replacement bulb can be purchased through your local AEG Service
Force Centre (Part No: 647072580).
1
Warning!
Never use standard light bulbs in your Lavatherm.
0
Isolate the appliance from the mains supply.
0
Screw-off the bulb cover. (The bulb is located at the top behind the
door; see
Front view
).
0
Replace the defective bulb.
0
Screw-on the bulb cover.
1
Warning!
For safety reasons the bulb cover must be screwed-on. The
dryer must not be operated, without the cover in place.
The drum illumination does
not work
The program selector is in
the OFF (AUS) position
Turn the program selector
dial to LIGHT (BELEUCH-
TUNG)
The bulb needs replacing Replace bulb
The dryer terminates the
drying process automatically:
END (ENDE) is displayed
shortly after program start
Too dry or too little
laundry filled-in for the
selected program
Select time program or
higher drying stage (e.g.
EXTRA DRY (EXTRATRO-
CKEN) instead of VERY
DRY (STARKTROCKEN))
The drying process takes
unusually long. 4.5 hours
after the beginning of the
drying process:
- END (ENDE) display is illumi-
nated
- acoustic signal sounds
- discontinuation of the
drying process
- Program run display is flash-
ing
SPECIAL CARE (SCHON)
button pressed and too
much laundry filled-in
Check the program
selection: SPECIAL CARE
(SCHON) button
appropriate only for
laundry amounts up to
2.5kg
Too much laundry
filled-in
Reduce the amount of
laundry filled-in
Laundry too damp
Pre-dry the laundry more
thoroughly
Symptom
Possible cause
Solution
