5
Tripod and Sheave Mounting
1.
Extend the three Tripod legs (Figure 6 Item 1) fully away from the center of the unit until
it is in a stable position. The Sheave Assembly (Figure 6 Item 2) is mounted to the center
eyebolt with the use of a Mounting Clip (Figure 6 Item 3).
2.
Remove the Quick Release Pin (Figure 6 Item 4) by pulling it out of the Sheave Assembly.
Thread the camera cable through the Sheave Assembly following the direction of the
arrow. Lay the cable over the Sheave Wheel in the center with the cable head in the
direction of the arrow.
3.
Place the Quick Release Pin (Figure 6 Item 4) back into position to trap the cable, once
the Mounting Clip (Figure 6 Item 3) is clipped to the assembly.
4.
Adjust the length of legs by lifting the red Lock (Figure 6 Item 5) and sliding each leg to
the desired length. Lower the red Lock back to lock the leg in place.
NOTE: For this Tripod and Sheave, the camera is required to be connected after feeding
the Cable Head (Figure 3 Item 1) through the Sheave Assembly.
Ensure power is OFF (Figure 5 Item 3) before disconnecting the camera.
Figure 6
1
0
2
0
3
0
4
0
5