Important notes:
› LAVA
®
DESK 120 from EthERMA complies with the relevant
safety requirements.
› Installation and initial start-up, as well as repairs and ser-
vicing, may be carried out by a licensed specialist or quali-
fied individual only. All safety regulations must be observed.
Such individuals must first verify whether the indoor electri
-
cal system corresponds to the relevant standards. the re-
sponsibility of the manufacturer is limited to supply of the
device.
›
Comply with country-specific safety regulations.
› Comply with local safety precautions.
› the devices are suitable for installation under desks and on
walls.
› Protective areas must be observed in accordance with DIn
VDE 0100, part 701, when installing the device in bathrooms.
› Minimum distances must be adhered to.
Installation and minimum distances:
the desk heater is rear-mounted by screwing to a desk or to a
suitable surface. there are four holes provided for this purpose.
Screws for mounting to wood are included in the product con-
tents; suitable mounting screws must be used for mounting
to other surfaces such as brickwork or similar. these are not
included in the scope of supply.
the preferred position for installation is in the desk's knee
area. the constant temperature measured at the heating ele-
ment should not exceed 65 °C, not caused by heat coming from
external sources e.g. external heating. trapped heat must be
avoided. the manufacturer shall not be held liable for any dam-
ages that may result from failure to observe the operating and
installation manual.
Installing the design infrared heater:
Please inspect the power supply cord to the heater and the
surface before installation. these must not show any signs of
damage.
Installation under desks and on walls:
1. Drill holes on the underside of the desk surface or the wall -
in so doing, please observe the hole spacing provided.
2. Affix LAVA
®
DESK 120 and tighten screws fully.
C A u t i o n : Strain of any kind on the surface, whether from
persons or objects leaning against it or from other forces,
must be avoided.
u S A g e A n D i n S t A L L A t i o n i n S t r u C t i o n S
35 mm
35 mm
35 mm
35 mm
3
I n s t a l l a t I o n a n d u s a g e I n s t r u c t I o n s | l a V a
®
d e s K 1 2 0