LIGHTING INSTRUCTIONS
Open the cabinet door, put the gas cylinder into the cabinet
Turn the control knob clockwise to “OFF” position.
Connect the regulator to the gas bottle. Turn the gas supply “ON” at the cylinder.
Check with the use of soapy water for any gas leakage between the bottle and the
regulator
Push down the control knob and keep pressing whilst turning anti-clockwise to the
“Ignition” position (a click will be heard), this will light the pilot. If not repeat this
process.
When the pilot burner is lit, keep the control knob pressed for 5 seconds then release
it.
If the burner does not stay alight, repeat steps 3 and 4. If the burner has not lit wait 5
minutes and repeat steps 3 and 4.
Adjust the heat setting by turning the control knob to the high or low position.
To turn the heater ‘OFF’ turn the cylinder valve or regulator switch to the ‘OFF’
position and then turn the control knob on the appliance clockwise to the ‘OFF’
position.
WARNING:
If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder
valve off. Wait five minutes before attempting to relight with ignition sequence.
CLEANING AND CARE
Make sure all the cleaning is done after turn off the heater and cooling down.
Wipe off powder coated surfaces with soft, moist rag.
Do not clean heater with cleaners that are combustible or corrosive.
Remove debris from the burner to keep it clean and safe for use.
Open the top back door to clean debris on glass carefully.
STORAGE
1. Always close the gas valve of the gas cylinder after use or in case of a disturbance.
2. Remove the pressure controller and the hose.
3. Check the tightness of the gas valve and for damage. If you suspect a damage, have it
changed by your gas dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places without adequate air
ventilation
7
