![Launch FX9000 User Manual Download Page 15](http://html1.mh-extra.com/html/launch/fx9000/fx9000_user-manual_3902586015.webp)
9
FX9000 User Manual
vehicle differences and gradual changes that occur over time.
2.6 OBD II Monitors
An important part of a vehicle’s OBD II system is the Readiness Monitors, which
are indicators used to find out if all of the emissions components have been
evaluated by the OBD II system. They are running periodic tests on specific
systems and components to ensure that they are performing within allowable
limits.
Monitor operation is either “Continuous” or “Non-Continuous,” depending on the
specific monitor.
2.6.1 Continuous Monitors
Some of the vehicle components or systems are continuously tested by the
vehicle’s OBD II system, while others are tested only under specific vehicle
operating conditions. The continuously monitored components listed below are
always ready:
1. Misfire Monitor
This Monitor continuously checks for engine misfires. A misfire occurs when the
air-fuel mixture in the cylinder does not ignite. The misfire Monitor uses changes
in crankshaft speed to sense an engine misfire. When a cylinder misfires, it no
longer contributes to the speed of the engine, and engine speed decreases each
time the affected cylinder(s) misfire. The misfire Monitor is designed to sense
engine speed fluctuations and determine from which cylinder(s) the misfire is
coming, as well as how bad the misfire is.
There are three types of engine misfires, Types 1, 2, and 3.
•
Type 1 and Type 3 misfires are two-trip monitor faults. If a fault is sensed
on the first trip, the computer temporarily saves the fault in its memory as a
Pending Code. The MIL is not commanded on at this time. If the fault is found
again on the second trip, under similar conditions of engine speed, load and
temperature, the computer commands the MIL “On,” and the code is saved in
its long term memory.
•
Type 2 misfires are the most severe type of misfire. When a Type 2 misfire
is sensed on the first trip, the computer commands the MIL to light when the
misfire is sensed. If the computer determines that a Type 2 misfire is severe,
and may cause catalytic converter damage, it commands the MIL to “flash”
once per second as soon as the misfire is sensed. When the misfire is no
longer present, the MIL reverts to steady “On” condition.
The Misfire Monitor is supported by both “spark ignition” vehicles and
Summary of Contents for FX9000
Page 56: ...50 FX9000 User Manual...