Lauda PROLINE Edition X P 12 C, Operating Instructions Manual

Page: 64 / 116

Proline Edition X heating thermostats
64
Starting up
YACE0099 / 10/9/2018
7.10.4 Creating or modifying a program (Edit)
Here, there are the following functions:

Entry of a program.

Display of the program data of a saved program and modification of the segment data.

Insertion or appending of a new segment.

Deletion of a segment.


In addition, when a program has just been executed, new segments can be inserted
and existing ones modified, even the currently active segment. Furthermore, all
segments, except the currently active one, can be deleted at any time.

Modifications to the currently running segment are possible. The segment then con-
tinues as though the modification had been applicable since the start of the seg-
ment.
However: If the new segment time is shorter than the segment time that has already
run, then the program skips to the next segment.

If a segment time >999h:59min is required, then this time must be shared over a
number of consecutive segments.
Entering a program: Program example (

7.10.1).
Command
Programmer Program1 Edit Modify

In the Edit menu one can Modify or
Delete a program.

Press the key.

Continue to Modify . with the key . .

There is the possibility of modifying single
segments, i.e. segments can be entered
as new, changed and also deleted.
No. T end °C Time [h:m] Tolerance
Start 30,00°C ------- 3,00°C
1 30,00°C 00:30 3,00°C
Pump Menu End Insert Delete

In the "Start" line enter in the field "T end
°C" the temperature at which the se-
quence is to start (default value is 30 °C).
A time entry is not possible in the "Start"
segment, because the thermostat imme-
diately executes Segment 1 on reaching
the start temperature.

Delete single segments (rows) with
Delete .

For thermostats without cooling ability,
the setpoint temperature must be obtain-
able, i.e. above the bath temperature dis-
played at the time of the program start!
Pump Menu End T
set
T
fix
Status
Edit
Loops
Graph
Info
Modify
Delete