Lauda IN 1030 T, Operation Manual

Page: 110 / 200

Setting Description
Pump In Integral T the pump is switched on or off. No
pump levels can be set.
In the Integral XT the pump level can be entered
with which the segment is to be processed.
S1, S2, S3 The switching state (off or on) of a contact module
(if installed) can be entered here. Contact modules
are available as an accessory.
Examples of the functions of a contact module
n
Functions of the inputs

Set fault

Set standby

Control programmer

Control change mode (2 different set temperatures)

Regulate internal or external control
n
Functions of the outputs

Signal various error states

Signal standby

Specify position with respect to a temperature window (inside or
outside)

Specify programmer status

Signal refilling
Fig. 63: Program example
The graph shows an example of a reprogrammed set temperature profile.
The cooling time in the graph varies depending on the device type, consumer
and so on. In example segment number 2, 50 °C should be reached within
20 minutes.
The original values in the first table below (before) are represented by a solid
line, while the values in the edited profile in the second table (after) are
represented by a dashed line.
Editing program examples
V6 Integral Process Thermostats and High-Temperature Thermostats 110 / 198