User Instructions
Datasheet No.: VERTI_96
DAR No.: 5306mc
Issue: 4
Issue Date: 19.01.2016
Approved: A.Pass
Sheet 12 of 15
© Copyright 2016 Latchways plc
No part of this document may be reproduced or transmitted in any form or by any means,
without prior permission in writing from Latchways plc.
CAUTION!
DO NOT USE ANY SOLVENTS, THINNERS OR ANY CHEMICAL CLEANING AGENT.
9.11. If it is anticipated that the device is to be used in wet, very cold conditions between -4 and -30°C
apply a small amount of WD 40 water dispersant to the area between the cam and the side plates.
Following application of the WD 40 allow any excess dispersant to drain away and wipe any surplus
from the device using a clean lint free cloth.
9.12. Storage
– The device should be stored away from excessive heat, high humidity, sharp edges,
corrosives or other foreseeable causes of damage. The equipment should not be subjected to
unnecessary stress, pressure or rough handling. Wet equipment should be dried naturally away from
direct heat.
9.13. Transport
– during periods of transportation the device should be stored carefully in a kit bag.
Cam
Apply WD 40 between the cam and
each of the side plates
