3 - Setting Up Your Machine
Page 06
3.3 - Cutting Unit Installation (Standard & Special Sizes)
3.3.1
3.3.2
3.3.3
3.3.4
3.3.5
Loosen the Top Yoke Wing Nut (50-34) on the right hand side of the Top Yoke (50-15) and swing the Top Yoke
toward you to obtain access to the Cutting Unit Cavity in the Table Ring Casting (50-14).
Making sure the Adapter Hold Down Tab (50-11) is not in the way, insert the Adapter Plate (50-26) into the Table
Ring Casting. Make sure that the Adapter Plate Rotation Tab (50-12) slips under the Table Ring Casting into its
designated groove to prevent unwanted rotation of the Adapter Plate. Turn the Adapter Hold Down Tab so that it
locks the Adapter Plate into place.
Insert the Cutting Unit into the Adapter Plate.
Swing the Top Yoke back into its original position making sure it is fully engaged in the Yoke Slide Rod (50-04).
Tighten down the Top Yoke Wing Nut to secure in place.
Depress the Foot Pedal to engage the cutting cycle making sure to check that the Cutting Unit is working
properly.
Adapter Hold Down Tab (50-11)
Top Yoke (50-15)
Pressure Foot Assembly
(50-201A)
Top Yoke Wing Nut (50-34)
Wood Table (50-29)
Cutting Unit Cavity
Yoke Slide Rod (50-04)
Side Guide (50-03R)
Side Guide (50-03L)
Standard / Special Size
Cutting Unit (Misc Part #)
Adapter Plate (50-26)
Adapter Plate Roation Tab (50-12)
Table Ring Casting (50-14)
