5 - Maintenance
Page 09
5.2 - Annual Lubrication
5.2.1
5.2.2
5.1 - Safety
ALWAYS DISCONNECT THE POWER BEFORE PERFORMING MAINTENANCE
ON THIS MACHINE. MAINTENANCE SHOULD ONLY BE PERFORMED BY A
QUALIFIED TECHNICIAN.
KEEP HANDS CLEAR WHILE PERFORMING MAINTENANCE ON THIS MACHINE.
MOVING PARTS CAN CRUSH AND CUT.
Lightly oil the two Yoke Slide Rods where they enter the adapter ring approximately every two weeks or as needed
depending on use.
Remove the back panel and lightly oil the connection where the Draw Bar and Cam Bar pivot every 30 days or as
needed depending on use.
6 - Troubleshooting
6.1 - Determining the Cause and Correction to Certain Problems
Problem
Cause
Correction
Machine won’t start
Power supply insufficient
Inspect and test power supply
Machine makes a squeak
during operation
This is inherent in the motor itself
and is a normal during operation
No correction is needed
Fuse has blown
Replace fuse
Grinding noise from motor
when stopping or reaching
full cycle
Faulty Brake-Hub Assembly
Contact a Qualified Service
Technician
Machine will not cycle or cut
material
Material is too thick or too hard
Decrease the size of the stack
you are attempting to cut
