Floor panel BVC-6501 (not included in the delivered set)
Vandal proof panel with colour camera and integrated light source (LED), loudspeaker,
microphone and call pushbutton. Panel is mounted on the plaster. In the panel there is
transmitter releasing the electro-catch after pressing the pushbutton in the monitor.
Dwg. 4 Floor panel BVC-6501
Service of installation procedure (requires activation in CD system)
During activated monitoring from the camera of CD system we should press quickly
a few times pushbutton CONVERSATION (signalling diode LED1 and LED2 will light)
and then pushbutton LOCK. Electronic cassette of CD system will search monitor after
founding it monitor number will be reproduced in the loudspeaker. Sound signals will
be generated according to the number of hundreds, tens and unities of the programmed
number. Longer break means passing to next digit in the programmed number and longer
duration of sound signal means zero value of a given digit.
If pushbutton LOCK is not pressed within 30 sec the procedure will be stopped automatically.
After finishing of number reconstruction it is possible to select calling signal for this
monitor by sequential pressing pushbutton LOCK; pushbutton CONVERSATION is used
for changing calling volume. Four volume modes are possible: quiet, intermediate, loud
and increasing (three short signals of increasing frequency).
After having made the changes pushbutton CONVERSATION should be pressed and
held for a moment, then the centre will call back to monitor and the fitter will be able to
check the functioning of acoustic track and electro-catch.
3. Monitor programming
In standard delivery in each monitor number 63 is programmed. This is a test number
and even in apartment 63 it should be programmed again.
Programming should be done directly after monitor connection and its mounting.
Programming should be done when monitor power supply is cut off.
Note!
In the monitor apartment numbers within a range 1...255 can be programmed. Programming
a number bigger than 255 is not possible. Number 0 should not be programmed!
Each such attempt will cause programming of default number 63.
Programming is done by means of pushbuttons: PROG (in the monitor rear part), LOCK
and CONVERSATION as well as signaling diodes LED1 and LED2.
Page
4
LASKOMEX PPUH, ul. D¹browskiego 249, 93-231 £ód, tel. (42) 671 88 00, fax (42) 671 88 88, e-mail: [email protected], http://www.laskomex.com.pl
Camera
LED (lighting)
Loudspeaker
Pushbutton
Microphone
red
VC
black
GND
white
audio
violet
video
yellow
electrocatch
brown
electrocatch
MVC-6650
Installation and activation
