Laskomex Bastion Draco II, Manual

Page: 6 / 12

6
Pin to J102 socket
Pin to J103 socket
Pin to J100 socket
(power supply)
LASKOMEX PPUH, ul. D¹browskiego 249, 93-231 £ódŸ, tel. (42) 671 88 00, fax (42) 671 88 88, e-mail: laskomex@laskomex.com.pl, http://www.laskomex.com.pl
Red
+
Black
-
- Connect the wires to the J102 socket connector provided with the kit, as shown in the diagram, by
soldering them to the wiring system. Protect all soldered connections and isolated portions of the
wires against short-circuit with a shrinking sleeve or insulating tape. Plug the connectors to the sockets.
- Mount the monitor on the holding bracket.
Installing and connecting the additional monitor (max 4)
For connecting two or more MVC6601 monitors (max 4) to a single outdoor panel, runa separate
power supply (J100 socket) to the additional monitor and connect the two monitors. See Figure
8, 9 and 10. Set jumper JP2 in the last most remote monitor from external panel. JP2 -
Matching the impedance to the coaxial cable.
fig 4. Sticker on the back of the monitor and plugin added to kit to connecting monitor
Installing and connecting the BVC-6601 outdoor panel.
- Unscrew the screw holding the panel to the hood.
- Place the hood at the intended place of installation, mark holes for the rawl plugs and drill the holes
(Fig. 5b). The camera lens should be placed at a height of approx. 150 cm (see Fig 5a).
- Pull the wiring system cable through the circular hole in the casing and fasten the casing to the wall
(Fig. 5c).
- Connect the wires according the diagram (see Fig. 6, 7, 8 and 9). As shown in Fig. 5, the wires
should be connected to the outdoor panel with snap-on connectors (see Fig. 4). Place the panel
against the hood and secure it with the mounting screw (Fig. 5D).
fig 5. Outdoor panel instalation
Installing and connecting the power adapter
The wire marked with a grey dotted line is plus, and the solid black one is minus – see Fig. 3. The
wires should be connected according to the connection diagram.
Model: MVC-6601
J102
J103
wideo
Vcc+
masa
audio
wideo Vcc+ masa audio
J100
- +
JP2
JP1
JP3
JP3: Oœwietlenie przycisku wywo³ania
(w zale¿noœci od stosowanego panelu).
JP1: Potwierdzenie wywo³ania
w panelu zewnêtrznym.
JP2: dop. impedancji do kabla
konc.
J100: Gniazdo zasilania 15V DC
J103: Gniazdo panelu zewnêtrznego nr.2
J102: Gniazdo panelu zewnêtrznego nr.1
Red
audio
White
wideo
Yellow
Vcc+
Blue
masa
Red
audio
White
wideo
Yellow
Vcc+
Blue
masa
a) b c) d
150 cm