![background image](http://html1.mh-extra.com/html/lasko/ultra-air-t48335/ultra-air-t48335_operating-manual_4041881003.webp)
NEW 11/18
3
T48335ES
MODEL T48335
REMOTE CONTROL
1. Install two “AAA” batteries (not included) as shown in
Figure 4
.
2. All the functions performed with the Remote Control work
identically to the Manual Controls.
3. Do not mix old and new batteries. Do not mix alkaline, standard
(carbon-zinc) or rechargeable (nickel- cadmium) batteries.
4. DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY
EXPLODE OR LEAK.
Figure 2
Support Base
Assembly
Power Supply
Cord
Thumb Screws
Figure 1
Support
Base B
Support
Base A
Tabs
Slots
Key
ASSEMBLY
1. For ease of assembly, lay the Fan down so that the front grill
and control panel are facing up.
2. Assemble the Support Base Halves by interlocking the
Tabs
on
Support Base A
into the
Slots
on
Support Base B
.
(Figure 1)
3. Align the
Support Base Assembly
with the Motor Base. Make
certain to align the
Key
on the
Support Base Assembly
with the
Locating Notch on the Motor Base. Attach the
Support Base
Assembly
to the Motor Base with
Thumb Screws
(Figure 2)
.
OPERATION
This Fan may be operated by the Manual Controls located on front
of the unit
(Figure 3)
or by the Remote Control
(Figure 4)
.
1. Place the Fan on a firm and level surface.
2. Plug the cord set into a 120 volt outlet.
Be sure that the plug fits tightly into outlet.
When plugs fit loosely into receptacles, they may slip
partially or completely out of the receptacle with only
the slight movement of the attached cord. Recepta-
cles in this condition may overheat and pose a serious
fire hazard; if covered by a curtain or drape, the fire
hazard is even greater.
3. Apply power to the Fan by pushing the
Power Button
( ). The
Fan will initially operate in High Speed, speed 3.
4.
FAN SPEED:
You may now adjust the Fan speed to the desired
level, 3, 2, or 1 by pressing the Fan
Speed Button
( ).
5.
OSCILLATION:
Press the
Oscillation Button
(
) to start and
stop the oscillation function.
6.
TIMER FUNCTION:
This Fan is equipped with a timer. The timer
can be set for 1-8 hours. Continue pressing the
Timer Button
( ) to reach the desired time setting. To cancel timer, press
Timer Button
( ) until lights are extinguished.
7.
NIGHTTIME FEATURE:
Press the
Nighttime Button
( ) once
to turn function on. The lights on the Fan will dim 50%. Fan
will run on High (3) for one hour, change to Medium (2) for one
hour, then finally switch to Low (1) until user interacts with Fan.
Nighttime feature does not work with any other function, except
Oscillation. Press any other button to cancel Nighttime feature.
8. After turning the Fan off, unplug the unit from the electrical outlet.
Figure 4
Power Button
Speed Button
Timer Button
Oscillation
Button
Nighttime
Button
Figure 3
Fan Speed
Button
Oscillation
Button
Timer
Button
Nighttime
Button
Power
Button