Laski Predator, Operating Instructions Manual

Page: 34 / 59

Predátor P 56RX
34
Indicator lamp
„6“ - green – all engine in-service parameters are OK
- red – error message registered and displayed
If the engine turns automatically off just after starting, it may be a
symptom of automatic disconnection. Detect the cause and
remedy the failure, see also chap. 7.
Despite the disconnecting automatics you should keep regular
intervals of 8 – 15 hours intended for engine oil checks.
Reasons for automatic engine stop: emergency stop button pressed (External stop), engine
oil pressure too low (Low oil pressure), alternator error (Lacko f chargé alternator), cooling
fluid temperature too high (High water temperature).
Putting into Operation
- Do not use the machine under conditions of low visibility, especially at foggy
weather, when you may overlook persons coming. Operate it only at daylight or
with sufficient lighting.
- Every operator of this machine is fully responsible for any injury or damage
caused to the third persons, animals and property within the operating reach of
the machine.
- Observe the working area. To ensure the maximum life of the cutters and to
keep the cutters sharp, contact with soil, stones, flint brick and other hard
materials around the base of the tree stump or directly in the stump should be
kept to an absolute minimum.
- Avoid going with the tracked chassis over contingent obstacles, such as stumps,
walls etc. that could cause unnecessary wear to the rubber track and its
mechanism and could also cause a track to come off.
- Avoid going or working on slopes with inclination exceeding the permissible
limit of 11
o
.