Manual: Laserworld Garden Star Series
GS-200RG move; GS-250RGB move
English
English Version: Legal notice:
Thank you for purchasing this Laserworld product.
Due to continual product developments and technical improvements, Laserworld (Switzerland) AG re-
serves the right to make modifications to its products.
This manual and its content have been made with due care but Laserworld (Switzerland) AG cannot
however, take any responsibility for any errors, omissions or any resulting damages forthwith.
The brands and product names mentioned in this manual are trade marks or registered trade marks of
their respective owners.
Operating instructions and usage policy without localised Laser Health and Safety guidance and
professional installation: The laser systems of the Laserworld Garden Star Series are intended for
private use. If this laser system is used in public space, there will be other directives for class 3R.
This device is no toy and must not be operated by minors or children!
For public installations, please contact your local Laserworld representative for guidance upon instal-
lation with support from a Local HSE (Health and Safety Executive). With clear professional advice and
qualified installation by a recognised HSE or LSO (Laser Safety Officer), the Garden lasers are suitable for
installation in public areas if installed to the local legal requirements for safe use.
1. Product and package contents
Please check if all listed parts are included and undamaged. Included in delivery:
1 x laser light effect
1 x remote control unit
1 x manual
1 x power supply unit
1 x stake
3. Initial operations, safety instructions
1.
Make sure to use
correct voltage
; see infor-
mation in this manual.
2.
Make sure that the device is
not connected
to mains
during installation.
3.
Installation has to be done according to sa-
fety regulations of the respective country.
4.
If the device has been exposed to
great
temperature changes
, do not switch it on
immediately. Condensation may damage
device.
5.
Never use dimmer, RC or other electroni-
cally switched sockets.
6.
Ensure
sufficient ventilation
and do not
place the device on any warm or heat radi-
ating surface. Ensure that the device does
not get overheated
.
7.
Operating temperatures: -35° C to +40° C:
8.
The operation of the device below -15°C
(-25° C) may result in reduced output pow-
er and below -35° C) laser output may stop.
This is not a deficiency, but derives from
general physical principles. When the tem-
peratures rise above the given temperatures
the laser runs at normal level again.
2. Preliminary warning notices
1.
Please use this device only
according to these operating instructions
.
2.
Do not use the device if there are any
visible damages
on housing, power adapter or power
cords.
3.
Never look directly into the light source
of a laser projector.
4.
This device is manufactured according to protection class IP65. It is dust-proof and protected
against temporary submergence.
Do not operate the device under water.