Manual / Bedienungsanleitung: EL-60 G/EL-100 B/EL-120 R
Version / Stand: September 10
Page / Seite 4 of / von 8
Operation requirements
The operator has to make sure that laser radiation – also reflected laser radiation – higher than the maximum
permissible level is avoided by technical or organisational measures
Make sure to use the correct voltage. Always use a grounded mains connection. Don’t use a remote controlled
or other electronically switched main connection. Don’t use together with large appliances (especially fog
machines/hazers) on the same mains.
If the device is used in a flying installation, the mounting brackets and an appropriate safety-rope must be
fixed.
In some countries the operator must notify the accidence insurance and the authority for industrial safety
before operating a laser. For more information contact the relevant authorities.
Please consider that unauthorized modifications on the device are strictly forbidden due to safety reasons!
If this device will be operated in any way differently than described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
Keep surrounding dry and clean. T
his unit should be keep dry, do not use in the rain or damp and dusty
environment, don’t place liquid filled receptacles on the device. Projector should be put in a water-proof
housing when operated outside.
Regularly open the device (see “cleaning” further down) to check for dust inside, or if fog fluid condenses in
the housing (if so rearrange hazer and/or laser position).
Operating temperature is 10~35
°C
. In a new installation, check after some 15-30 minutes whether the outlet
air gets too warm. Regularly check the inside for dust deposits, especially around the fans. Let laser cool off
10 minutes after 2 hours of operation, to ensure maximum lifetime for the diode. Be careful not to direct
stage lights toward the laser (especially moving heads), this can cause overheating.
Distance between laser aperture and projection screen should be not less than 1 meter.
Do not turn device on and immediately off again frequently.
Do not look into the laser beam directly, especially not with optical instruments.
Do not touch the device with wet hands.
When the laser diode becomes dim or broken, please contact your dealer timely.
When returning laser to dealer/manufacturer always use original packaging.
Maintenance should be performed every 15-day period. See “cleaning” further down.
Operation
Caution – use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
Connect the power cable to the mains and turn on the power switch. Now the device operates in
the stand-alone-mode. You can control the music-sensitivity of the microphone with the min-max
knob at the front panel. The LED flashes when the device is triggered.
Maintenance / cleaning
Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing the 4 upper screws and lifting the top. Remove any deposits of dust,
especially at the fan. Check for condensed fog fluid inside. If so, clean and rearrange the position of
laser and or hazer.
Mirrors need cleaning when a “halo” is noticeable around the beam or an
unusual high amount of diffuse light can be seen inside the device.
Clean the mirrors with window
cleaner and a paper towel.
Never look directly into the light source. Always disconnect from the mains when the
device is not in use or before cleaning it.
Troubleshooting
Problem
Possible cause
No function / fan not working
Check mains connection
Effects don’t change to the beat of the music Adjust sensitivity with the dial on the front.
Device not working, but fan working
Turn device off for ca. 1 Minute.
