USER MANUAL: Laserworld CS-400RGY
Date: 01/2008
Page 5 of 9
3. OPERATION
Please note: for sound/DMX mode the two switches on the back
of the device labelled “BLANKING” and “X/Y” have to be up.
When both switches are down the device can be controlled by
an ILDA output (such as our USB-Box). Use this switch setting
only when connected to such an ILDA controller. Even if you
disconnect/interrupt the ILDA connection only for a short
period, always put the switches into up position, or turn the
device off!
4. AUTO- MUSIC-MODE
If you put switch 10 to “ON” the patterns will change automatically, and are
animated by sound (sound or music mode), the switches labelled “BLANKING” and
“X/Y” have to be up. You can control the music-sensitivity of the microphone with
the min-max knob on the rear panel. With switch 1 you can select two modes:
standard sound mode (patterns will move triggered by sound), and animated sound
mode (patterns will move slowly without sound and will be accelerated with sound).
5. OPERATION WITH DMX
If you turn switch 10 to “OFF”, and switches “BLANKING” and “X/Y” up, the device is
in DMX mode. Set the DMX address and connect the device to a DMX controller, you
can then operate you CS-200G ECO with DMX.
Set the DMX address code with the binary system “0” or “1”. A few examples:
DMX-
adress
DMX-
adress
1
65
17
113
33
161
