User manual: CS-400G
Rev: 02/2009
page2 of 6
Checking parts
Please check if all listed parts are included, and are not damaged.
1 x CS-400G laser
1 x power cable
1 x remote connector
2 x key
1 x manual
SAFETY INSTRUCTIONS
If the device has been exposed to great temperature changes,
do not switch it on immediately. Condensation water may
damage your device. Leave the device switched off until it has reached room temperature.
The laser must only be used for shows. Any operation has to be attended and supervised by
a skilled and well-trained operator.
Never leave this device running unattended and keep it away from children and unauthorized
persons.
Keep away from heaters and other heat sources. In order to safeguard sufficient ventilation,
leave 50 cm of free space around the device.
Never direct the laser beam to people or animals.
CAUTION LASER DIODE: Don’t open the housing!
There are no serviceable parts inside the device. Maintenance and service operations shall
only be carried out by authorized dealers. If you open the device for cleaning, always
disconnect from mains!
HEALTH HAZARD! Never look directly into the light source, as sensitive
persons may suffer an epileptic shock!
These lasers are considered a definite eye hazard, particularly at the higher power levels,
which WILL cause eye damage. So these laser series models supplied with a key switch to
prevent unauthorized use, warning labels and aperture labels affixed to the laser.
Installation safety
Prior to installation and operation of the laser, the paths of the beams and effects should be
considered, particularly with respect to how they will reach the audience. If direct audience
scanning is desired, then the laser energy in the effects needs to be considered to decide if
the effects are safe for direct viewing.
OPERATING THE LASER
The operator has to make sure that laser radiation – also reflected laser radiation – higher
than the maximum permissible level is avoided by technical or organisational measures.
Make sure to use the correct voltage
If the device is used in a flying installation, the mounting brackets and an appropriate safety-
rope must be fixed.
In some countries, the operator must notify the accidence insurance and the authority for
industrial safety, before operating a laser. For more information, contact the relevant
authorities.
Please consider that unauthorized modifications on the device are strictly forbidden due to
safety reasons!
If this device will be operated in any way differently than described in this manual, the
product may suffer damages and the guarantee becomes void. Furthermore, any other
operation may lead to dangers like short-circuit, burns, electric shock, etc.
Keep surrounding dry and clean. T
his unit should be kept dry, do not use in the rain or damp
and dusty environment. Projector should be put in a water-proof housing when operated
outside.
