LaserMech FiberCUT 2D, Operation Manual, Page: 32 / 68

PLMNL0232 REV. H Effective Date: 01/14/19
32
FiberCUT
®
2D Operation Manual
Figure 36
The calibration function is also
available through the Industrial
Ethernet interface (see
Appendix E ).
The acceptable minimum and
maximum pressure limits can be set
as desired within the stated range
according to the following (see
Figure 37 ):
1. Click the Settings menu in the
upper left corner of the Main
screen and hover over
Pressure
Limits . Click on the desired limit
to set.
2. Enter a desired lower or upper
limit within the stated range
using the provided value field.

The purge pressure limits
are in mbar relative to the
calibrated ambient
pressure.
3. Click OK to apply the settings.
Figure 37
Pressure readings outside the
acceptable range result in a fault
condition.

To Disable or Suppress the
Low Purge Fault

To disable faults generated
by a purge pressure reading
below the lower limit
permanently, set the lower
limit to zero.

To suppress the lower limit
temporarily, click on the
Suppress Low Purge Fault
or set the corresponding
Industrial Ethernet bit. See
Figure 38 .