USER MANUAL
SPK-BT15
6
in which the pair must be completed. Usually up to 30 seconds depending on your
device. Once this time has elapsed you may need to begin the process again.
Note 4: After pairing is successful, paired devices will remember each other. Unless a new
device has been paired, re-pairing is not required during subsequent uses of the same
device.
Note 5: If you want to pair the speaker with other devices, please make sure the last device
has been disconnected, and then pair it with the new device according to the steps
mentioned below. SPK-BT15 cannot be connected with 2 devices at the same time
1.
Turn the unit on using the sliding power switch on the side of the unit.
2.
The speaker will default to Bluetooth mode (indicated by the word “bLUE” on the
screen. (otherwise use the MODE button to toggle)
3.
The unit is now in “pairing mode”.
Mobile Phone (HSP – Head Set Profile)
Note 1: Please ensure your Bluetooth device supports the HSP Bluetooth profile before
configuring.
Note 2: Pairing procedures can vary slightly between Bluetooth devices. Please refer to your
mobile phone manual for further information where required.
1.
Open the Bluetooth function of your mobile phone and start the “search” for
Bluetooth devices service.
2.
Once the SPK-BT15 is located, it will appear on your device list. Then, select the
device.
3.
Depending on your settings, a password may be required to pair with the SPK-BT15.
In this case use the code “0000” (four zeros).
4.
Once completed successfully, you are now able to connect to the SPK-BT15 using
the “connect” option.
iPad or iPhone
1.
Turn the Bluetooth function on via the Settings > General > Bluetooth menu.
2.
Swipe the ON/OFF switch to ON. The message “Now Discoverable” will appear
3.
SPK-BT15 should the soon be identified by your iPhone/iPad.
4.
Select it to complete the pairing. The device is now ready for use.
PC (or Notebook)
Note: Before installing this product, please make sure your PC or device supports Bluetooth,
that the Bluetooth feature is enabled and that the Bluetooth dongle has been installed
correctly and with current firmware updates
1.
Activate Bluetooth connectivity on your PC and begin the SEARCH NEW DEVICE
function.