L'Artistico A10 Series, Installation And Instruction Manual

Page: 31 / 152

PELLET STOVES
(Rev. 15/10/2013)
ENG
><
13. CONNECTING TO THE EXTERNAL AIR INLET
The air inlet diameter should be not less than 60 millimeters and the maximum piping length is 1 meter and one 90°
bend. The stove is fitted as standard with an 80 millimeters connection. In this case the maximum length can be 1,5
meters and one 90° bend. When connecting the stove with an external air inlet you will get an exceptional level of
comfort and operation softness. The stove will properly burn even in case you cannot connect it to an external air
inlet but get the combustion air from the room. The UNI 10683 shows the minimum air volume in the room to be
respected. For all other countries, respect all local and national regulations in force.
14. ELECTRICAL CONNECTION
Check for the wall plug to be adequate to the stove electrical requirements: 230V/50Hz and 350Watt. Make sure the
electrical cord doesn’t get in touch with any hot part of the stove, doesn’t run over the smoke connection, a proper
earth is available and a proper circuit breaker is fitted. In case of irregular power supply (normally in remote or
mountain areas), do not worry bat your stove is protected with two 5X20 4A STD between the main switch and the
cord plug on the rear panel. Check the fuses before installing the stove.