1660K005G
Page 5 of 26
Parameter 1: Date configuration:
This parameter configures de date, as well as the wintertime/summertime
automatic switchover configuration. When entering this parameter, the day can be changed using the
Increase and Advance key. To switch to month configuration, press the Enter key. Navigation here is the
same as before. Once set the month, press the Enter key to switch to year configuration. Navigation here is
the same as before. Once set the year, press the Enter key to switch to the following parameter, which has
two parts:
Left digit: wintertime/summertime automatic switchover configuration
0 - Automatic switchover disabled. Time offset must be changed increasing or reducing value
in parameter 3, leaving as the internal time, the UTC time.
1 - Automatic switchover enabled.
Right Digit: Weekday.
It allows to configure the present weekday, where 1 is Monday and 7 is Sunday
Parameter 3: Time offset:
This parameter allows the user to configure its time zone, as well as changing the
time offset in summertime/wintertime when configuring it manually, or for personal purposes; always counting
that internal time count of the clock is GMT. First digit shows an upper hyphen when adding time and a
hyphen when subtracting
Parameter 4: Display configuration
: This parameter configures other functionalities of the display, as the
brightness and the sync options.
Brightness configuration consists of two parts:
Left digit. Manual or automatic control of brightness
0 - Automatic control of brightness depending on the room light.
1 - Manual control of brightness. Fixed brightness depending on the right digit.
Right digit. Brightness level.
The functionality of this digit depends on the left digit:
Automatic
mode
– Selection of the minimum brightness of the display when the room is in
darkness. Minimum brightness is 1 and maximum is 5. With light, the display adapts to the amount of
light in the room.
Manual mode
- Selection of the brightness level. 1 is minimum and 5 is maximum brightness
The second parameter (Accessed through the Enter key once selected the brightness configuration)
configures the time sync depending on the capabilities and the user desires. If the user selects a sync not
allowed by capabilities, the display will not sync. For example, a display without Ethernet connection, selecting
SNTP sync will have no effect. Options are:
0. Do not sync.
1. Sync with another display through Ethernet.
2. Sync through SNTP.
3. Sync with another display through RS-485.
4. Sync through GPS.
Parameter 5: Display power-up time:
This parameter configures the time the display changes form power-
.save mode to full-operative mode. When accessing in this parameter, the hour the display changes to full-
operative mode is shown. When the Enter key is pressed, the minutes are shown. To go back to the
parameter menu, press the Enter key again.
Parameter 6: Display power-down time:
This parameter configures the time the display changes from full-
operative mode to power-save mode. When accessing in this parameter, the hour the display changes to
power-save mode is shown. When the Enter key is pressed, the minutes are shown. To go back to the
parameter menu, press the Enter key again.
