2
•
12
0
V
AC
or 24
0
V
AC
power source. See
Speci
f
ications
for wattage requirement.
Camera adjustments
1.
Apply power to the camera.
2.
Verify that video from the camera can be seen on a monitor.
NOTE
: Video from the CVBS drop able
or the video test cable is NTSC video and can be displayed on most NTSC compatible monitors.
Video from the HD-TVI drop cable must be connected to an HD-TVI compatible video recorder (DVR)
system.
3.
While observing video from the camera, loosen the mounting bracket pan, elevation and horizontal
line adjustment lock screws, point the camera at your surveillance target, and then tighten
adjustment lock screws or nuts to hold the camera in position.
USING THE OSD
Use the OSD to adjust the internal settings of the camera to customize it for the installation venue.
1.
Unscrew
the
lens
cover of the camera to access OSD joystick and WDR switch. See photos above.
OSD
joystick
p
q
t
u
Plug for
video test
cable
WDR
OFF/ON
switch
NOTE
:
If WDR switch
is ON, CVBS output
is disabled. The OSD
WDR setting overrides
the switch
ON
OFF
The OSD joystick is used to open the OSD menu and navigate through the menus. To open the
camera menus and select a menu option, press the joystick down (in toward the camera body). To
navigate the menus, rock the joystick up (UP (
p
), see photo above) or down (
q
) to move through
the parameter list menus vertically, rock the joystick left (
t
) or right (
u
) to change the parameter
value that appears for the parameter. Press the joystick down (in toward the camera body) to select
the parameter value shown. Changes made to the OSD setup must be saved to be restored after
power off and power on.
Most menus have a RETURN that returns you to the previous menu. EXIT closes the OSD.
2. Open the OSD menus by pressing the joystick in toward the base assembly. The OSD menu tree is
shown below. Use the OSD to configure the camera as needed.
OSD top level menu
For power hookups connect
A
C
Hot
to the
brown
wire and
A
C
neutral
to the
blue
wire using
the provided terminal strips.
Connect ground (green) to the terminal screw inside the housing.
Plug into you DVR
Larson Electronics LLC - 1.800.369.6671 - [email protected]
- larsonelectronics.com
