WDL-12-70W-LED-SFC-WCM
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
INSTALLATION
This fixture is shipped with preconfigured Housing Color, Color Temp, and Lens type. See product label for specific unit
received.
1.
Install fixture to surface via the mounting brackets. There are predrilled holes for mounting.
2.
If needed, open lens by unscrewing the two screws. Be careful not to drop lens or internal components when opening.
3.
Electrical voltages and frequency are listed on the product label for reference.
4.
For supply connections use conductors suitable for min. 90° C.
5.
Connect internal wires per wiring diagram, and wire through hub according to NEC requirements using conduit or
similar device.
6.
Replace lens and secure screws.
7.
Close all unused end caps.
MAINTENANCE
Electrical and mechanical inspection of all components must be performed on a regularly scheduled basic, determined by
the environment and frequency of use. It is recommended that inspection be performed a minimum of once a year.
WARNING:
ELECTRICAL POWER SUPPLY MUST BE
“OFF” BEFORE AND DURING INSTALLATION AND
MAINTENANCE. INSTALLATION AND MAINTENANCE PROCEDURE MUST BE PERFORMED BY A TRAINED AND
COMPETENT ELECTRICIAN.
1.
Inspect all contact wire terminals for tightness. Discoloration due to excessive heat is an indicator of a possible
problem and should be thoroughly investigated and repaired as necessary.
2.
Inspect contacts for signs of wear and replace if necessary.
3.
Clean exterior surfaces making sure nameplates remain legible.
If any part of the light appears to be missing, broken, or show signs of damage
—discontinue use immediately! This
condition could cause serious or fatal personal injury due to electrocution and/or equipment damage. Repair with the
proper replacement part(s) before continuing service.
MAINTENANCE
Caution:
To avoid personal injury, disconnect power to the light and allow the unit to cool down before
performing maintenance.
Warning:
No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens will void
the warranty.
1.
Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine
checks to be
made on a yearly basis. Frequency of use and environment should determine this. It is
recommended to follow
an Electrical Preventive Maintenance Program as described in NFPA 70B:
Recommended practice for
Electrical Equipment.
2.
The lens should be cleaned periodically as needed to ensure continued photometric performance.
Clean the
lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid
cleaner.
3.
Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or
contamination (i.e.
excessive dust build-up). Clean with a non-abrasive cloth if needed.
4.
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
WDL-12-70W-LED-SFC-WCM
is designed to provide years of reliable performance. Should the need for
replacement parts arise, please contact Larson Electronics.