WAL-TP.S-RL16-LED
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
USING THE TRIPOD
1.
To assemble the tripod, begin by loosening the black adjustment knob on the
tripod base. Slide the center pole through the adjustment sleeve until the legs
are fully deployed. Tighten adjustment knob so legs stay fixed in place.
2.
Loosen black adjustment knob for each sleeve to extend tripod. Extend top
pole, then bottom pole when elevating.
3.
Tighten adjustment knob once desired height is achieved.
OPERATION
The
WAL-TP.S-RL16-LED
features a rechargeable LED light head that produces 1000 lumens of high-intensity LED light
on the high setting and 500 lumens on the low setting when less lighting power is needed or desired. A single sealed push
button allows the operator to easily switch between high and low settings.
Do not look directly into lens when powering.
Lamp can be adjusted independently with the adjustment bolt holding it in place. Tighten bolts once desired angle is
achieved.
Battery/Charging
The rechargeable lithium ion battery powers this light for up to 4 hours on high and 8 hours on low. The WAL-TPS-RL16-
LED is shipped with both an AC and DC charger power supplies. Recharging from a fully depleted state takes 6 hours.
- Light Head
Adjustment
Points
-Leg Sleeve
MOUNTING
The WAL-TPS-RL16-LED is equipped with an adjustable aluminum tripod that can reach heights up to 10 feet and can be
lowered to 3.5 feet for applications where a lower height is required or for storage and transportation. The heavy duty
aluminum tripod is durable, lightweight and adjustable to any length between 3.5 feet and 10 feet. A single mounting
bracket holds the LED light and allows it to be adjusted and aimed horizontally and vertically. This adjustability allows
users to expand the area covered or to focus more intense coverage on a smaller area. The tripod legs can be collapsed
and the light head bracket removed with the light still on it for simple portability and deployment. The heavy duty
construction of this tripod and the light weight of the LED fixture results in a portable yet very stable lighting platform that
will hold its position, even in very windy conditions.
MAINTENANCE
There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the
fixture for proper function.
•
Disconnect power running to the lamp and be sure the fixture is cool to the touch.
•
Use a non-abrasive glass cleaning solution to clean the lens.
Note: It is not necessary to open the fixture and clean or touch the LED’s.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The EPP-20A-25P is designed to provide years of reliable performance. Should the need for replacement parts arise,
please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
