WAL-C-4XM
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
Replacing the Bulb
1.
To replace the bulb, loosen the
screw to remove the outer ring holding the
lens.
2.
Carefully remove the outer ring, glass lens
and rubber seal.
3.
Remove the old bulb from the unit.
4.
Replace with 1000 watt BT56 lamp.
See
part# WAL-SB-1000W-MH to purchase
replacement bulb.
5.
Replace the seal, glass lens and outer ring. Hand tight the outer ring until snug. Do not
over tighten.
LIGHT MAST OPERATION
1.
Position light mast in the desired
location. Ensure that the unit is
completely level
and ensure the
mast is free and
clear from any overhead obstructions.
Deploy legs to stabilize mast.
2.
(If applicable) Attach equipment to
mast
head.
Use
appropriate
measures for securing attached
devices. Drill thru-holes as necessary.
Do not exceed weight capacity
listed on nameplate!
3.
Install mast head.
See mast head
installation steps.
4.
Use the hand winch for extending the mast. Turn this clockwise until it stops. You should hear a clicking noise from
the hand winch indicating the proper direction. Do not force the winch any further pas
t
its stopping point!
5.
To lower the mast, rotate the upper winch counter-clockwise. The winch will not click at this point and you should
visually see the mast lowering. Stop once there is no more tension on the cable. Do not allow excessive slack on
winch cable.
6.
Mate the cord cap with a compatible receptacle outputting the correct voltage
to power lights
.
Check product label to verify correct input voltage!
•
WARNING: Power cables can become pinched or tangled around light mast while lowering or rotating. Take
caution in keeping cables clear
.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
WAL-C-4XM
is designed to provide years of reliable performance. Should the need for replacement parts arise,
please contact Larson Electronics.
