WAL-C-4XM
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
Portable Light Tower -
4 X 1000 Watt Metal Halide Lights
Instruction Manual
Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this instruction sheet.
Read carefully before operating. Retain these instructions for future reference.
WARNING:
IMPORTANT
READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. THE WAL-C-4XM MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE
AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS
PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION
SHEET, CONSULT AN ELECTRICIAN.
The WAL-C-4XM is a mounted mini light tower and provides 400,000 lumens of light output. This portable light tower has a removable
four light head assembly mounted on top of a four leg steel TOWER equipped with 8 inch wheels for easy positioning of the unit from one
area of the workspace to another. The light assembly on this unit produces a wide flood pattern of light that is ideal for illuminating large
workspaces and job sites. This light is designed for heavy duty use in demanding conditions including emergency services, mining,
construction, marine, and industrial operations where durability and portability is important.
This portable light tower is comprised of a removable light assembly fitted with four metal halide lamps mounted atop a four leg tripod
fabricated from heavy duty steel. This adjustable and collapsible tower can be extended to fourteen feet and collapsed to seven feet and
is locked into position with t-handle locking pins. The unit is extended and lowered using an included hand crank cable winch equipped
with a brake for fast and safe deployment. Included solid wheels allow the operator to tilt the unit back and simply roll the entire assembly
to a new location when fully deployed. The light fixture assembly can be removed by releasing the hand knob and sliding the light and
mounting bracket off of the center support while the legs can be collapsed, aiding in deployment, storage and transport. The lamps can
be easily adjusted up, down or from side to side independently of each other and locked into position for maximum coverage of the work
area.
MAST HEAD INSTALLATION
1.
Locate light head. Color, style, and mounted lights will vary.
2.
The light head is equipped with a T-Handle / Hand Screw.
3.
Make sure the hand screw is loose, to allow the head to slide over the top stage of the
mast.
4.
Using a pair of slings, wrap both slings around the light head in between the lights on both
sides.
5.
Attach the slings to a forklift or other lifting device.
6.
With 2 people holding the light head steady, slowly raise the light head above the mast.
7.
A ladder will need to be placed on both sides of the mast, in order for 2 people to guide the
head in to place.
8.
Once the light head is on top of the light mast, tighten the T-Handle to ensure the light head
is safely secured to the top of the mast.
9.
Slings are recommended for
installing heavy loads and to ensure operator safety. Should
other methods be used, Larson
Electronics shall not be held responsible for damages or
personal injuries.
WARNING:
MAKE SURE POWER IS TURNED
OFF
BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
RISK OF PERSONAL INJURY –
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.
